Panasonic ES-LT7N Operating Instructions Manual page 16

4
4
Pour tap water ( 1 ) and
detergent ( 2 ) into the
cleaning liquid unit.
• Do not let the water rise
above the maximum water
line. This may cause the
cleaning liquid to spill.
• Pour the entire packet of detergent (approximately 15 mL).
5
5
Attach the cleaning liquid unit.
• Immediately wipe up any cleaning liquid
that has been spilt.
Be careful not to drop cleaning liquid
onto leather products or wooden floors
as it may cause discoloration.
6
6
Press the top of the self-
cleaning recharger down and
securely attach until it clicks.
► Notes
• The water and detergent will mix after cleaning begins, making
cleaning liquid.
• If the LOW lamp or the STATUS lamp glows for 5 seconds when
the SELECT button is pressed, the cleaning liquid needs to be
replaced. Replace the cleaning liquid.
• After the LOW lamp glows, you can clean the shaver with the
self‑cleaning recharger for approximately 7 days.
• When replaced, the cleaning liquid will last for approximately
30 days if used once per day. (This will differ depending on beard
thickness and the ambient temperature.)
16
ES-LT7N_US.indb 16
• Use the detergent within approximately 6 months after opening the
 
• Replace the water and detergent at the same time.
• Only use self‑cleaning recharger detergent for Panasonic shavers.
►Cleaning the shaver
• Rinse the shaver in water if there is some soap or shaving gel on it.
• When the shaver is wet, shake off excess moisture and then
1
1
2
2
3
3
4
4
• The "Charge" mode starts when attaching the shaver.
• Each time you press the SELECT button, the mode changes
• The modes start approximately 6 seconds after they are selected.
• The mode will be aborted if the power is cut off. In this case,
• Do not press the cleaning liquid unit removal button as the
package. When 6 months have passed, discard the cleaning liquid,
and then pour new water and detergent into the cleaning liquid unit.
Otherwise the cleaning function may deteriorate.
Failure to do so may cause damage or malfunction.
wipe off any remaining droplets.
Constituent of the cleaning liquid may alter, which could cause
damage or bacterial contamination.
Insert the appliance plug into
the self-cleaning recharger.
Remove the protective cap
and then attach the shaver.
• Slowly insert the shaver into the
self‑cleaning recharger taking care
not to damage the system outer foil.
• Wipe off any water droplets on the
main body rear terminals.
Plug in the adaptor into a household outlet.
Press the SELECT button to select the mode.
from "AUTO" "Dry/Charge" "Charge".
perform the mode again from the beginning.
cleaning liquid may spill causing a malfunction.
2
3
1
2015/04/17 17:45:28