.......8 rechargeable battery .....22 Charging the shaver ....9 Specifications ......22 Using the shaver....10 Thank you for purchasing this Panasonic product. Before operating this unit, please read these instructions completely and save them for future use. ES-LT8N_AUS(EN).indd 2015/05/13 20:04:30...
Safety precautions WARNING To reduce the risk of injury, loss of life, electric shock, fire, and ►Power supply damage to property, always observe the following safety precautions. Do not connect or disconnect the adaptor to a Explanation of symbols household outlet with a wet hand. - Doing so may cause electric shock or injury.
Page 3
WARNING Never disassemble except when disposing of the product. - Doing so may cause fire, electric shock, or injury. Always ensure the appliance is operated on an ►Cleaning electric power source matched to the rated voltage indicated on the AC adaptor. Always unplug the adaptor from a household outlet Fully insert the adaptor.
Page 4
WARNING Do not forcefully press the system outer foil. Also, do not touch the system outer foil with fingers or nails when in use. Do not store within reach of children or infants. Do Do not use this product for hair on head or any not let them use it.
Page 5
►Disposing of the rechargeable battery CAUTION DANGER Do not drop or hit against other objects. - Doing so may cause injury. The rechargeable battery is exclusively for use with Do not wrap the cord around the adaptor when storing. this shaver. Do not use the battery with other products. - Doing so may cause the wire in the cord to break with the Do not charge the battery after it has been removed load, and may cause fire due to a short circuit.
► Notes • Treat yourself to wet lather shaves for at least three weeks and notice the difference. Your Panasonic WET/DRY shaver requires a little time to get used to because your skin and beard need about a month to adjust to any new shaving method.
►Unlocking the power switch Operation and display of the switch lock 1. Press the power switch for 2. Once the shaver starts ►Locking the power switch more than 2 seconds. operating, release the power switch. 1. Press the power 2. Press the power 3.
Charging the shaver While charging After charging is completed Charging using the self-cleaning recharger Insert the appliance plug into the self-cleaning recharger. The charge status lamp ( The battery capacity lamp and Remove the protective cap glows. the charge status lamp ( while pressing the side of The number of the battery will light up and then turn off...
Using the shaver Charging without the self-cleaning recharger Insert the appliance plug into Press the power switch. the shaver. • The power cannot be turned on when the switch lock lamp • Turn the shaver off before inserting. ) blinks, as the power switch is locked. Press the power switch for more than 2 seconds to unlock.
Page 11
• Depending on the beard thickness or the amount of beard ►Using the trimmer trimmings in the shaver head, the shaving sensor may not react Slide the trimmer handle up to the “ ” and the driving sound may not change. This is not abnormal. position so that the trimmer stands upright.
Cleaning the shaver Reading lamps when using While using Cleaning using the self-cleaning recharger Approximate amount of battery capacity is The self‑cleaning recharger cleans the inner blades and the displayed as 20 ‑ 100. system outer foil. Brush or wash with water to remove beard •...
Page 13
• Do not let the water rise Otherwise the cleaning function may deteriorate. above the maximum water • Only use self‑cleaning recharger detergent for Panasonic shavers. line. This may cause the Failure to do so may cause damage or malfunction.
Page 14
Cleaning the shaver without the self-cleaning recharger Remove the adaptor after the selected mode is completed. Do not use kitchen, bathroom, or toilet detergents. Also, do not wipe with thinners, benzine, alcohol etc. Mode Time required (guide) Doing so may result in malfunction. Charge 1 Charge 1.
Page 15
8. Attach the outer foil section to the shaver. Cleaning with the brush 9. Lubricate the shaver. ►Drying the shaver with the self-cleaning recharger ►Cleaning with the long brush 1. Attach the outer foil section to the shaver. Clean the system outer foil ...
Page 16
►Removing the outer foil section ►Replacement parts Press the foil frame release buttons and lift the Replacement parts are available at your dealer or Service Center. outer foil section upwards. System outer foil and inner WES9015 blades Replacement parts for ES‑LT8N System outer foil WES9089...
If the problems still cannot be solved, contact the store where cleaning tray with a cotton swab dampened you purchased the unit or a service center authorized by with water. Panasonic for repair. ►Self-cleaning recharger Problem Action If the shaver is not cleaned for...
Page 18
Problem Action Problem Action Check that the AC adaptor is During cleaning: connected to the self‑cleaning The self‑cleaning recharger recharger, and that the adaptor is makes a loud sound due to the plugged in to a household outlet. cleaning of the blades. (See page 13.) After cleaning: The self‑cleaning recharger...
Page 19
Problem Action Problem Action If you mix soapy water or hand Apply oil. soap with the detergent or use (See page 15.) another detergent, the cleaning System outer foil gets hot. Replace the system outer foil if it liquid will foam. Use the self‑ The cleaning liquid has is damaged or deformed.
Page 20
Problem Action Problem Action The appliance may not operate in Depending on the beard thickness an ambient temperature or the amount of beard trimmings Shaver stopped approximately 5 °C or lower. in the shaver head, the shaving functioning even after sensor may not react and the charging.
Page 21
►When the STATUS lamp of the self-cleaning recharger glows It will light up for approximately 5 seconds every time the SELECT Question Answer button is pressed. The drying time for the “Dry/ Problem Action Charge” mode is set longer as there may still be excess moisture Pour new water on the grip or areas other than the...
• Perform steps 1 to 4 and lift the battery, and then remove it. Question Answer • Take care not to short circuit the positive and negative terminals Constituent of the oil is liquid of the removed battery, and insulate the terminals by applying paraffin.