Preset Setup - Samsung SCC-C7478 User Manual

How to use OSD Menu

PRESET SETUP

PRESET SETUP
PRESET NO.
<EDIT SCENE>
<LABEL>
CLR PRESET
CAM ADJUST
ALARM OUT
BACK
EXIT
• Preset Number
If a selected preset is already defi ned, camera moves
to pre-defi ned position and preset characteristics
such as Label and Relay Outputs show on monitor.
If a selected preset is not defi ned, "UNDEFINED"
shows on monitor.
• Edit Scene
Redefi ne current Preset scene position (i.e. PTZ).
• Label
Edits Label to show on monitor when preset runs.
MAX. 10 alphabets are allowed.
• CLR Preset
Delete current Preset data
• CAM Adjust
WB(White Balance) and AE(Auto Exposure) can
be set up independently for each preset. There are
2 modes, "General" mode & "Special" mode. The
General mode means that WB or AE can be set up
totally and simultaneously for all presets in "CAMERA
SETUP" menu.
The Special mode means that WB or AE can be
set up independently or separately for each preset
in each preset setup menu. Each Special WB/AE
value should activate correspondingly when camera
arrives at each preset location. During jog operation,
General WB/AE value should be applied.
All Special WB/AE value should not change although
General WB/AE value changes. If "Special'' is
selected, Menu to set WB/AE shows on monitor.
• Alarm out
State of four alarm outputs can be freely controlled in
conjunction with Preset run. The character "-" means
OFF state and the number representing each bit
means ON.
Ex) If it is set to be -23-, Output relay 2, 3 will be ON
and 1, 4 will be OFF, when you run this Preset.
22 – 36x SMART DOME CAMERA
1
WINDOWS
CANCEL
GENERAL
----
[1~128]
[CANCEL/OK]
[GENERAL/SPECIAL]
❖
Edit Preset Scene
EDIT SCENE - PRESET 1
MOVE TO TARGET POSITION
[NEAR:SAVE / FAR:CANCEL]
① Using joystick, move camera to desired position.
② By pressing NEAR or ENTER key, save current
PTZ data.
③ Press FAR key to cancel.
❖
Edit Preset Label
LABEL - PRESET 1
[█
----------
1234567890
ABCDEFGHIJ
KLMNOPQRST
UVWXYZabcd
efghijklmn
opqrstuvwx
yz<>-/:.
① Edits label to show on monitor when camera
arrives at presets. In Edit Label menu, a reverse
rectangular is cursor. As soon as fi nishing
selecting alphabet, cursor moves to the next digit.
[
Current Cursor Position
② Using Left/Right/Up/Down of joystick, move to
an appropriate character from the Character set.
To choose that character, press the NEAR or
ENTER key.
0/0/x1/N
]
OK
CANCEL
]