Makita JS3200 Instruction Manual page 6

2
3
4
1. Hex wrench
2. Lower blade
3. Upper blade securing bolt
4. Upper blade
1
2
1. Tighten
2. Upper blade securing bolt
3. Upper blade
1
2
3
1. Blade holder
2. Upper blade securing bolt
3. Upper blade
4. No gap allowed
1
2
3
1. Lower blade positioning bolt
2. Lower blade
3. Upper blade
6
When all eight edges are dull on both the upper and lower blades, replace both
004679
blades with new ones. Each time blades are rotated or replaced, proceed as
1
follows.
Remove the blade securing bolts with the hex wrench provided and then rotate
or replace the blades.
Install the upper blade and tighten the upper blade securing bolt with the hex
004682
wrench. Press up on the upper blade while tightening it.
3
After securing the upper blade, be sure that there is no gap left between the
004683
upper blade and the bevelled surface of the blade holder.
4
Then install the lower blade like the upper blade while adjusting the clearance
004684
between the upper blade and lower blades. When performing this adjustment,
the upper blade should be in the lowered position.