Press
four times. LCD will display the message:
Press
. LCD will display the message:
Press all the buttons in the displayed order: a double beep indicates
the button is ok, a long beep indicates the button is broken.
6.6. System Info
Use this function to check TechMaster firmware version.
Power up TechMaster and access the Configuration Menu. LCD will
display the message:
Press
five times. LCD will display the message:
Press
to check information.
7. Opening the Locks
7.1. Users (or OVR Users): Opening the lock without Time Delay
Power up TechMaster and select the lock when two or more locks are installed.
LCD will display the message:
Enter a valid user code and insert the Dallas key, if set-up. LCD will
display the message:
Invalid code will prompt LCD to display the message
Open the door within 3 seconds.
Before power-off, LCD will display current date and time.
7.2. Users (or OVR Users): Opening the lock with Time Delay
Power up TechMaster and select the lock when two or more locks are installed.
IU_TechMaster_02_eng
MEMBRANE TEST
ü
1234567890
INSTALL
LOCKS
SYSTEM INFO
USER CODE
X X – X X X X X X
OPEN
WRONG CODE
11:44
WED
01 / 09 / 2010
Page 23 of 32