Removing The Refrigerator Doors - Samsung RF4287HA User Manual

• Do not install the refrigerator where the
temperature will go below 10ºC (50ºF).
• Do not locate the refrigerator where it may
become wet.
When moving your refrigerator
To prevent fl oor damage, be sure the front
adjusting legs are in the up position (above
CAUTION
the fl oor).
Refer to 'Adjusting the doors' in the manual
(on page 9).
Flat-blade Flat-blade
Control Lever Control Lever
screw driver(-) screw driver(-)
FLOORING
For proper installation, this refrigerator must be placed
on a leveled surface of hard material that is the same
height as the rest of the fl ooring. This surface should
be strong enough to support a fully loaded refrigerator.
To protect the fi nish of the fl ooring, cut a large
section of the cardboard carton and place it under
the refrigerator where you are working. When moving
a refrigerator, you need to pull and push it straight
forwards or back. Do not wiggle it from side to side.
ACCESSORIES AND REQUIRED
TOOLS
The following accessories are included with your
refi gerator:
06_ setting up
DA68-01922B-14.indb 06 DA68-01922B-14.indb 06
Hex wrench Hex wrench
Required Tools (Not provided)
You need the following tools to complete the
installation of your refi rgerator:
Philips screwdriver Philips screwdriver Flat-blade Flat-blade
(+) (+) screwdriver (-) screwdriver (-)
Pliers Pliers Allen wrench (3/16") (5mm) Allen wrench (3/16") (5mm)
REMOVING THE REFRIGERATOR
DOORS
Some installations require door removal to transport
the refrigerator to its fi nal location. Do not remove the
door/drawer if you don't need to. If you do not need
to remove the refrigerator doors, go to Adjusting the
Level on page 8. If you need to remove the doors.
continue below.
Before removing the door/drawer, make sure you read
the following items:
Disconnect power to the refrigerator before
WARNING
removing the door or drawer.
• Be careful not to drop, damage or scratch
the door/drawer while removing them.
• Be careful not to get injured while removing the
door/drawer.
• Reattach the door/drawer properly to avoid:
- Moisture from air leakage.
- Uneven door alignment.
- Wasting energy due to improper door seal.
Fastener Fastener
Socket wrench Socket wrench
(10mm) (10mm)
2013. 12. 10. 2013. 12. 10. 6:22 6:22