Installation; How To Mount Monitor Stand; How To Remove Monitor Stand Mounting Bracket; Screw Holes For Wall Mounting Bracket - Panasonic WV-LW1900 Operating Instructions Manual

Installation

Important:
• Before installation work, remove all the connected cables and turn off the power of this monitor.
• Do not block the ventilation opening.
• Install this monitor at a vibrationless place. Installation of this monitor at a constantly vibrating place may cause trouble.

How to mount monitor stand

The monitor stand (accessory) is mounted. Use of supplied cushioning protects this monitor from being damaged.
Monitor stand mounting
screw (M4) (accessory)
Rectangular holes
Protrusions

How to remove monitor stand mounting bracket

Mounting screw (M4)
Stand cover
Mounting screw (M4)

Screw holes for wall mounting bracket

• Check the weights of the wall mounting bracket and this monitor.
• First, check the wall strength of the mounting position because the pull-out strength of the mounting position should be at
least 5 times more than the total weight of the wall mounting bracket and this monitor.
20
Monitor stand (accessory)
Monitor stand
mounting bracket
Cushioning
Monitor stand
mounting bracket
z Mount the monitor stand (accessory) onto the monitor
stand mounting bracket.
Ensure that the protrusions of the monitor stand mount-
ing bracket pass through the rectangular holes on the
bottom face of the monitor stand respectively.
x Use 4 pieces of the monitor stand mounting screws (M4
x 10) (accessories) to secure the monitor stand firmly.
Recommended tightening torque: 0.98 N·m {10 kgf·cm}
z Remove 1 piece of the stand cover mounting screw (M4
x 15), and then remove the stand cover.
x Remove 4 pieces of the screws (M4 x 15) securing the
monitor stand mounting bracket, and then remove the
mounting bracket.
Note:
• The removed stand cover, monitor stand mounting
bracket and screws should be retained for future use.
• To mount the monitor stand mounting bracket and stand
cover again, observe the following recommended tight-
ening torques:
Monitor stand mounting bracket: 0.98 N·m {10 kgf·cm}
Stand cover: 0.784 N·m {8 kgf·cm}