Faults & Errors - Projecta PC400 Instructions Manual

FAULTS & ERRORS
There are 6 possible error signals that may be displayed. These are explained in the
following table:
Fault Bulk
(Red LCD) (Blue LED)
Solid On
–––––
Flashing
– – –
Solid On
–––––
Solid On Solid On
––––– ––––––
Solid On
–––––
Solid On Flashing
––––– – – –
12
Full Rejuv
(Green LED) (Amber LED)
Flashing
– – –
Flashing
– – –
Fault
Battery Initiate Rejuvenation
problem has mode. If it fails again
been detected the battery may be
faulty
Short circuit Check the clips are not
or reverse touching each other
connection OR
of the clips Check the clips are
correctly connected
to the battery
Battery Battery may
problem has be faulty and may
need to be replaced
been detected
Bulk charging Battery may
has timed out be faulty
and stopped
after 24 hours
Over Move charger to
temperature a cooler location
OR
Check fan is
working properly
Soft Start has Check battery or
timed out remove any load
on the battery
Remedy