AEG SR 4363 CD Instruction Manual page 5

English
36
Reverse (not shown)
DC 5 V power adapter socket
AUX input
MIC (microphone input)
USB port
Underside (not shown)
Battery compartment
Start-up of the device/introduction
• Select a suitable location for the device, such as a dry,
flat, non-slip surface on which it is easy to operate the
machine.
• Ensure that the device is sufficiently ventilated!
• Remove the protective film from the display if it is still
present.
Power supply
• Make sure the grid voltage corresponds to the figures on
the rating plate.
• Plug the power supply unit into a properly installed
protective contact socket.
• Connect the device with the power supply unit by plug-
ging the jack of the power supply unit into the "DC 5 V
" jack.
CAUTION:
• This device should only be used with the mains supply
unit (included). Do not use it for other devices.
• Only use a 5 V power supply unit (
supply unit may damage the device.
NOTE:
Disconnect from mains power supply during longer periods
of non-use.
Inserting the Batteries (not supplied)
1. Open the lid of the battery compartment on the bottom.
2. Insert 4 batteries of type UM 2/R14 1.5 V. Please ensure
that the polarity is correct (see the floor of the battery
compartment)!
3. Then close the battery lid.
CAUTION:
• Do not expose the batteries to high temperatures or di-
rect sunlight. Never throw batteries into the fire. There
is a danger of explosion!
• Batteries may leak and lose battery acid. If the device is
out of use for long periods, remove the batteries.
• Non-rechargeable batteries may not be charged.
• Chargeable batteries may only be charged under adult
supervision.
• Chargeable batteries must be removed from the toy
before they are charged.
CAUTION:
• Different battery types or new and used batteries must
not be used together.
• Batteries must be inserted with the correct polarity.
• Spent batteries must be removed from the toy.
• Batteries are not to be disposed of together with
domestic wastes. Dispose of the used batteries at the
relevant collection bin or at your dealer' s .
• The terminals may not be short-circuited.
NOTE:
When the power adapter is connected, the device will
automatically disconnect the batteries.
Setting the clock
The system must be in standby mode in order to set the
clock.
1. Press and hold the
2 seconds. "24H" starts flashing in the display.
2. Use the
display format.
NOTE:
If the 12-hour format has been selected, "AM" will be
displayed in the morning.
3. Press the
hour indicator starts flashing.
4. Use the
5. Press
). A different
6. Use the
7. Press
NOTE:
• The clock time settings will be erased in the event of
power interruptions.
• If you do not press any button within 4 seconds, the
settings are adopted automatically.
Transport Safety Device, CD Compartment
1. Open the CD compartment (1) by pressing the OPEN/
CLOSE button (3).
2. Before operating the machine for the first time, remove
the transport safety device from the CD player if it is still
in place.
Turning device on/ off
• Press the
• To turn off the device, keep the
for approx. 3 seconds.
NOTE:
After about 15 minute without a signal, the device will
automatically switch to standby.
button (10) for approx.
/ buttons (9) to select 24-hour or 12-hour
button to confirm your settings. The
/ buttons to set the hours accordingly.
again. The minute digits start flashing.
/ buttons to set the hours accordingly.
again.
button (10) to turn the device on.
button pressed