JVC RX-F10S Service Manual page 12

Home theater receiver

Hide thumbs Also See for RX-F10S:

Enlarged version

3.13 Removing the input board

(See Figs.16 and 17)

• Remove the top cover, tuner, video/audio board, DSP board,

secondary board, speaker terminal board and scart board.

(1) From the back side of the main body, remove the strain re-

lief attaching the power cord in the direction of the arrow.

(See Fig.16.)

(2) Remove the ten screws Q attaching the rear panel. (See

Fig.16.)

(3) Release the engagement sections f and remove the rear

panel from the main body. (See Fig.16.)

(4) From the top side of the main body, remove the tie bands

bundling the wires. (See Fig.17.)

(5) Disconnect the wires from the connectors (CN451, CN506)

on the input board. (See Fig.17.)

(6) Remove the screw R and screw R' attaching the input

board.

Reference:

When attaching the screw R', attach the wire clamp with

it.

(7) Take out the input board from the main body in the direc-

tion of the arrow. (See Fig.17.)

Reference:

Remove the connection 1 board on the input board as re-

quired. (See Fig.17.)

1-12 (No.MB264)

Strain relief

Power cord

Fig.16

Wire clamp

CN451

CN506

Fig.17

Rear panel

Wires

Input board

Connection 1 board

Table of Contents