Samsung AC***KN4DKH User Manual page 16

Cleaning and Maintaining
Problem
The wired remote
control does not
operate.
The air conditioner
is not turned on or
off immediately
with the wired
remote control.
The Timed on/off
function does not
operate.
The indoor unit
display blinks
continuously.
I want to get
cooler air.
The air is not cool
or warm enough.
16
English
• Check whether the
of the remote control display. In this case, turn off both the air
conditioner and the auxiliary power switch, and then contact a
service centre.
• Check whether the wired remote control is set for group control. In
this case, the air conditioners connected to the wired remote control
are turned on or off sequentially. This operation takes up to 32
seconds.
• Check whether you pressed the
control after setting the on/off time. Set the on/off time.
• Turn on the air conditioner again by pressing the
button.
• Turn off and then turn on the auxiliary power switch, and then turn
on the conditioner.
• If the indoor unit display is still blinking, contact a service centre.
• Operate the air conditioner with a electric fan to save energy and
enhance the cooling efficiency.
• In the Cool mode, cool air does not come out if the set temperature
is higher than the current temperature.
– MR-EH00 remote control: Press the Temperature button
repeatedly until the set temperature (minimum: 18°C) is set to
lower than the current temperature.
– AR-KH00E remote control: Press the Temperature button on the
remote control. Then rotate the Wheel until the set temperature
(minimum: 18°C) is set to lower than the current temperature.
• In the Heat mode, warm air does not come out if the set temperature
is lower than the current temperature.
– MR-EH00 remote control: Press the Temperature button
repeatedly until the set temperature (maximum: 30°C) is set to
higher than the current temperature.
– AR-KH00E remote control: Press the Temperature button on the
remote control. Then rotate the Wheel until the set temperature
(maximum: 30°C) is set to higher than the current temperature.
Solution
indicator is displayed at the bottom right
(SET) button on the remote
(Power)