Setting the SCSI ID Number
In most cases, there is no need to change the default settings.
However, if you have other peripheral devices connected in a SCSI chain, check if
their ID numbers conflict with that of the printer. Be sure to choose an unassigned ID
number.
ID number can be changed by using the SCSI ID No. switches (#1, #2, #3) [
1 below].
Table 1
SCSI ID No. switches
ID No.
#1
0
OFF
1
ON
2
OFF
3
ON
4
OFF
5
ON
6
OFF
7
ON
Setting the Terminator
The terminator setting can be changed by using the terminator switch (#4).
Terminator
ON:
Terminator
OFF:
#2
#3
OFF
OFF
OFF
OFF
ON
OFF
ON
OFF
OFF
ON
OFF
ON
ON
ON
ON
ON
SCSI ID No.
switches
Terminator switch
Setup
Table
37