Rheem 874 Owner's Manual And Installation Instructions page 64

BATHROOM1 AND BATHROOM2 CONTROLLERS
If only one Bathroom controller is to be installed, the standard Bathroom1 Controller (Rheem PN A299854)
or the Bathroom1 Deluxe controller (Rheem PN A299862) must be used. If two Bathroom controllers are to
be installed, one must be a standard Bathroom1 controller and the other must be a standard Bathroom2
controller (Rheem PN A299855) or one must be a Bathroom1 Deluxe controller and the other must be a
Bathroom2 Deluxe controller (Rheem PN A299863).
They have a minimum temperature setting of 37 C and a maximum temperature setting of:
874 series
872 series
The method of installation for the standard Bathroom1 and Bathroom2 controllers and the Bathroom1 Deluxe
and Bathroom2 Deluxe controllers is identical.
Choose a suitable location for each Bathroom controller, away from water, heat, and sunlight. The Bathroom
controllers are supplied with a 250 mm length of wire with connectors to mate with the Bathroom controller
cable.
Notes:
It is not recommended to have exposed wiring in a bathroom.
Do not apply sealant to the controller cable.
Bathroom controller (standard)
screw x 2
Bathroom Deluxe controller
screw x 2
Bathroom1 Deluxe and Bathroom2 Deluxe Controller Components
50ºC
50ºC
base plate
controller screw
Bathroom1 and Bathroom2 Controller Components
base plate
controller screw
Bathroom Deluxe Controller Components
foam packing
64
foam packing
SK6370-1 A3
2/08 REV-AD