Pioneer PDP-LX6090 Operating Instructions Manual page 84

15 Additional information
Problem
OTHER
• POWER ON indicator or
STANDBY indicator is quickly
flashing.
• An external device connected to
the USB terminal does not
operate.
• Photo data stored in digital still
cameras cannot be read through
the USB interface.
If the following error codes appear on the screen, check the corresponding items in the table.
Code
SD04 and SD11
SD05
Signal names for 15-pin mini D-sub connecter
Pin No. Signal name
1 R
2 G
3 B
4 Not connected
5 Not connected
6 GND (ground)
7 GND (ground)
8 GND (ground)
84
Downloaded From TV-Manual.com Manuals
En
Possible solution
• Internal protective circuits may have been activated. First turn a off on the flat screen TV, wait one
minute or more, then switch the power on again by turning a on. If the indicator is still flashing,
unplug the flat screen TV's power cord from the power outlet. Wait one to two minutes then plug
in the flat screen TV again. If this does not solve the problem, contact a Pioneer Service Center.
These are listed on your warranty card for each country. Alternatively, check the Pioneer Web site
(see back cover) for contact details.
• Check if the device is connectable to the display. (See page 66.)
• Re-insert the USB cable. (See page 66.)
• For connection, use a USB cable shorter than 5 m. (See page 66.)
• Check if the USB cable is properly connected. (See page 66.)
• First turn off a on the flat screen TV and then turn it on again in order to check if the external
device works correctly.
• Check if the external device works correctly after the USB device was restarted.
• Check if the digital still camera is in the viewing mode.
• Refer to the instruction manual for the digital still camera.
• Check if the device is connectable to the display. (See page 66.)
• Check if the digital still camera turns on.
Message
Powering off. Internal temperature too high.
Check temperature around PDP.
Internal protection circuit turns the system off.
Is there a short in speaker cable?
Check
Check if the ambient temperature of the flat screen TV is high.
Check the speaker cable connections between the flat screen
TV and the speakers.
Pin No. Signal name
9 +5 V
10 GND (ground)
11 Not connected
12 SDA
13 HD
14 VD
15 SCL