Cannot Install The Mp Drivers - Canon PIXMA mp800 User Manual

Cause Action
The installation place, distance,
When printing through infrared communication, confirm that the infrared
and/or angle is improper. communication ports on both the machine and the mobile phone are placed
to face each other at the proper angle and distance, and that there is
nothing to block the communication between them, and then try printing
again. The proper distance and angle for communication vary depending
on the specifications of your mobile phone and on external environment.
Place the machine within 7.87" / 20 cm from the mobile phone for proper
communication.
During infrared communication, If infrared communication between the infrared ports of the machine and
infrared rays were interrupted or the mobile phone is interrupted by any obstacle for ten and several
another infrared communication seconds or longer during printing, the paper on which data is being printed
device is operating nearby. is ejected and the machine is reset. Remove the obstacle and retry printing.
If an infrared communication device is operating nearby, interference can
occur and fail in printing the document to the end. While printing a
document through infrared communication, do not operate another infrared
communication device, such as a remote controller of a TV, nearby.
The version of the infrared The infrared communication function of the machine is only compatible
communication port being used is with mobile phones with IrDA compliant infrared communication ports.
not compatible with IrDA. Printing through infrared communication cannot be performed by any other
types of mobile phones.
Cannot Install the MP Drivers
Reinstall the MP Drivers.
Unable to proceed beyond the
Printer Connection screen
t The printer could not be detected. Recheck
the connection
1. Click [Cancel] on the [Printer Connection] screen.
2. Click [Start Over] on the [Installation Failure] screen.
3. Click [Back] on the screen that appears next.
4. Click [Exit] on the [Welcome] screen, then remove the CD-ROM.
5. Turn the machine and ,the computer off.
6. Check the cable connection.
7. Restart the computer.
8. Make sure that no other applications (including anti-virus software) are
running in the background.
9. Carefully follow the procedures described in the Easy Setup
Instructions and reinstall the MP Drivers.
Chapter 12 Troubleshooting
131