Starting Transfer; Disconnecting Your M:robe From Your Computer - Olympus m:robe MR-500i User Manual

Starting transfer

After you connect your m:robe to your computer, m:trip automatically runs.
To start transferring, click the [Sync] button in the bottom right of your m:trip screen. Then, click [Start] in the
display that pops up to begin transfer.
During transfer, the LED of the device flashes.
When transfer is complete, the LED goes off, and the "DO NOT DISCONNECT!" message displayed on your
m:robe changes to "SYNCHRONIZATION COMPLETE IT IS SAFE TO DISCONNECT m:robe FROM
YOUR PC."
Tip
You can set m:trip not to run automatically when connecting your m:robe and your computer. For details, refer to the m:trip
online Help.

Disconnecting your m:robe from your computer

1
Check that the "SYNCHRONIZATION COMPLETE IT IS SAFE TO DISCONNECT
m:robe FROM YOUR PC" message is displayed on your m:robe.
2
Click the [Remove m:robe] button on the m:trip screen.
3
Take your m:robe out of the cradle.
When connecting your m:robe directly to the computer, disconnect the dedicated USB cable from your
m:robe.
Transferring music/photos from m:trip to your m:robe
29