Hertz H8 DSP User Manual page 31

H8 DSP
Digital Interface Processor
2. Save Setup: it enables the storage of the entire H8 DSP configuration in a file
(e.g. "H8Config.dip") that you can subsequently load into the H8 DSP through
the Load Setup function. This feature is available both in TARGET and in OFFLINE
modes.
3. FINALlZE to H8 DSP: it enables the loading of all the
parameters selected while configuring the H8 DSP into the
internal memory, allowing it to work without being connected to a PC.
When selecting the Finalize to H8 DSP function, the software
notifies you that the data previously saved to the H8 DSP will be overwritten.
- Select YES to load the data.
- Select NO to interrupt the process.
WARNING:
Before disconnecting the H8 DSP from the PC or each time that you exit the PC Software after modifying
the system configuration, always run the Finalize to H8 DSP procedure. If you do not follow these instructions,
all data entered will be lost and the device will use the previous settings.
4
Synchronize: PC -> H8 DSP, PC <- H8 DSP
These functions synchronize the PC with the H8 DSP.
If a dialog box like the one on the right appears, it means that for some reason
communication between the PC and the H8 DSP has been interrupted.
To restore the communication, select:
• PC -> H8 DSP. The PC loads the settings selected so far into the H8 DSP.
• PC <- H8 DSP. The PC loads the settings that have been previously stored
in the H8 DSP
WARNING:
This operation cannot guarantee that data are always retrieved.
If the operation is not successful, you need to:
1. exit the H8 DSP software;
2. turn the H8 DSP off;
3. turn the H8 DSP on;
4. launch the H8 DSP software again.
Synchronization will be restored but the selected settings will be lost
5 Check for updates: it enables the connection to the website
updates to the H8 DSP and DRC are available, in order to update the devices you are using. To perform this
operation, your PC has to be connected to the internet
6 Check for Updates on startup: when enabled the availability of new firmware/PC Software updates is checked
automatically each time you start the program.
7
Register product: This function requires an internet connection and opens the default browser to the page for
registering the product and creating a personal account in the "bit Drive" portal. This operation only needs to be
performed once; then you can access your account through the Login Account.
8.
Update Firmware: select to update the H8 DSP firmware
9. Reset Default Answer: it restores the display of warning messages if they have
been disabled by checking "Don't show me again".
10. Restore Factory Defaults: entirely resets the H8 DSP back to its default settings,
cancelling all data previously saved in the processor.
11.
Credits: it shows information about the H8 DSP software in use.
12. Exit: exits the PC software.
, and checks if any software / firmware
www.bitdrive.it
(see 9.3).
User's manual 8
31