Connections; Power Supply And Remote Turn On; How To Turn The H8 Dsp On / Off - Hertz H8 DSP User Manual

H8 DSP
Digital Interface Processor

5 CONNECTIONS

5.1

POWER SUPPLY AND REMOTE TURN ON

WARNING:
to power the device, use 1 mm2 (16 AWG) cables.
Black -BATT
5.2

HOW TO TURN THE H8 DSP ON / OFF

The H8 DSP is on when the POWER ON LED lights up in white. It can be turned on / off in the following ways:
1. Press the DRC main "POWER" switch (to turn on). Keep the DRC main "POWER" switch pressed (to shut down).
In this case, no other connections Remote In / KEY MEM are required, but they can coexist.
2. Connecting one of the Remote In plugs using a signal coming from a source.
The KEY MEM connection is not required, but it can coexist.
3.
Through the KEY MEM. This method is memory-dependent.
4. Through the MASTER (INPUT FL) input. The AUTO TURN ON (ART) function is enabled by connecting an amplified
head unit output to the INPUT FL input channel. This function can be disabled by moving the SPEAKER TURN ON
switch to OFF .
(seei 4; 5.5)
REM IN
Blue REM OUT
Red REM IN
Cyan (light blue) KEY MEM
Yellow +BATT 12V
1 mm - 16 AWG
2
Fuse Holder
Not Provided
Suggested Fuse
T1A-delayed
Ground
REMOTE OUT
+ -
12V
Battery Ground
Remark: the H8 DSP is internally protected by a
fuse-resistor soldered to its printed circuit
board. To replace it contact a service center.
Using an external fuse is recommended, though
it is not required.
User's manual
REM IN
(vedi sez. 5.2.2)
5
10