Technical Data; Noise/Vibration Information; Declaration Of Conformity - Bosch GDB 1600 WE Operating Instructions Manual

Technical Data

Diamond Drill
Article number
Rated power input
Output power
Rated speed n
0
– 1. Gear
– 2. Gear
Drilling diameter without drill stand
– in brick wall
– in concrete
Drilling diameter with drill stand
– in brick wall, optimal
– in brick wall, possible
– in concrete, optimal
– in concrete, possible
Tool holder
Water supply pressure (max.)
Weight according to EPTA-Procedure 01/2003
Protection class
* with suction head
The values given are valid for nominal voltages [U] of 230/240 V. For lower voltage and models for specific countries, these
values can vary.
Please observe the article number on the type plate of your machine. The trade names of the individual machines may vary.

Noise/Vibration Information

Measured values determined according to EN 60745.
Typically the A-weighted noise level of the machine is:
sound pressure level 87 dB(A); sound power level
98 dB(A). Uncertainty K=3 dB.
Wear hearing protection!
Overall vibrational value (vector sum of three direc-
tions) determined according to EN 60745:
Drilling in concrete: Vibrational emission value
2
a = 3 m/s , uncertainty K = 1,5 m/s
h
The vibration emission level given in
WARNING
this information sheet has been meas-
ured in accordance with a standardised test given in
EN 60745 and may be used to compare one tool with
another.
The vibration emission level will vary because of the
ways in which a power tool can be used and may
increase above the level given in this information sheet.
This could lead to a significant underestimate of expo-
sure when the tool is used regularly in such a way.
Note: To be accurate, an estimation of the level of
exposure to vibration experienced during a given period
of work should also take into account the times when
the tool is switched off and when it is running but not
actually doing the job. This may significantly reduce the
exposure level over the total working period.
3 609 929 A68 • 12.7.06

Declaration of Conformity

We declare under our sole responsibility that this prod-
uct is in conformity with the following standards or
standardization documents: EN 60745 according to
the
98/37/EC.
Dr. Egbert Schneider
Senior Vice President
Engineering
2
14.06.2006, Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
English–4
GDB 1600 WE
PROFESSIONAL
0 601 189 6..
W 1600
W
rpm 0 ... 980
rpm 0 ... 2400
mm 32–102*
mm 10–40
mm 52–132*
mm 32–152
mm 30–82
mm 10–102
1 1/4" UNC, R 1/2"
bar
kg
provisions of the
GDB 1600 DE
PROFESSIONAL
0 601 188 6..
1600
800
0 ... 980
0 ... 2400
32–102
52–132
32–152
1 1/4" UNC, R 1/2"
23
5.9
/I
directives 89/336/EEC,
Dr. Eckerhard Strötgen
Head of Product
Certification
800
–
–
–
–
5.5
/I