Olympus Stylus 780 Instruction Manual page 57

When you get an error message on the camera...
Monitor indication
q
There is a problem with the
CARD ERROR card.
q Writing to the card is
WRITE PROTECT prohibited.
> The internal memory has no
MEMORY FULL available memory and
cannot store any new data.
q The card has no available
CARD FULL memory and cannot store
any new data.
L
There are no pictures in the
NO PICTURE internal memory or on the
card.
r
There is a problem with the
PICTURE ERROR selected picture and it cannot
be played back on this
camera.
r
Pictures taken by other
THE IMAGE cameras, taken in [16:9], or
CANNOT BE previously edited or
EDITED corrected pictures cannot be
edited or fixed.
The battery/card
compartment cover is open.
CARD-COVER
OPEN
The battery is empty.
g
BATTERY EMPTY
This card cannot be used in
C A R D SE T UP
this camera. Or, the card is
not formatted.
POWER OFF
FORMAT
SET
OK
There is an error in the
M EM O RY S E TUP [ I N ]
internal memory.
POWER OFF
MEMORY FORMAT
SET
OK
The camera is not connected
to the computer or printer
NO CONNECTION
correctly.
There is no paper in the
printer.
NO PAPER
Possible cause Corrective action
This card cannot be used. Insert a new card.
The recorded image has been protected
(read-only) on a computer. Download the
image to a computer and cancel the read-
only setting.
Insert a card or erase unwanted data.
Before erasing, back up the data of
important pictures using the card, or
download such pictures to a computer.
Replace the card or erase unwanted data.
Before erasing, download important
pictures to a computer.
The internal memory or the card contains no
pictures.
Record pictures.
Use image processing software to view the
picture on a computer. If that cannot be
done, the image file is damaged.
Use image processing software to edit the
pictures.
Close the battery/card compartment cover.
Charge the battery.
Format the card or replace.
• Select [POWER OFF] and press e.
Insert a new card.
• Select [FORMAT] [YES] and press
e. All data on the card is erased.
Select [MEMORY FORMAT]
press e. All data in the internal memory
is erased.
Disconnect the camera and connect it again
correctly.
Load some paper in the printer.
[YES] and
57
EN