Remote Control - Kenwood K-521 Instruction Manual

K-521E_B60-5813-08_01_GVT0294-002A.indb 71 K-521E_B60-5813-08_01_GVT0294-002A.indb 71
Downloaded From Disc-Player.com Kenwood Manuals
Components connected to the D.AUDIO IN terminal
Symptoms
The main unit and Connect the player using the dedicated cable PNC-150.
Check whether the connected model is compatible.
remote control can-
not control a Kenwood
digital audio player.

Remote control

Symptoms
The remote control does Load new batteries.
Use the remote control within its eff ective range.
not work.
Resetting the microcomputer
Symptoms
Microcomputer mal- Malfunctions may occur due to an external cause or because a connec-
function (the system tion cord was unplugged while the system was turned on.
does not work, the Use the procedure below to reset the microcomputer.
display is faulty, etc.).
1 Unplug the power cord from the AC
wall outlet.
2 Plug the power cord back in while
holding down the power [K] key on
the main unit.
3 Upon the start of the microcomputer
resetting, the display shown on the
right appears.
4 When fi nish resetting, it turns to
Standby Mode.
Solution
Solution
Solution
During the resetting of microcomputer,
the display goes out.
Bear in mind that resetting erases any
stored information and restores the
system's default settings.
Troubleshooting
Ref. page
12
44
Ref. page
17
17
71
English
09.10.26 4:32:02 PM 09.10.26 4:32:02 PM