B P R , Vga60/480P, Sxga; Auto Search; Auto Signal; Sxga Mode - Panasonic PT-LB10NTU Operating Instructions Manual

AUTO SEARCH

This should normally be set to "ON"
ON
When the power is turned on and
"AUTO SETUP" is running, the
projector detects which signals are
being input and uses these signals
for projection.
(If a picture is being projected, the
signal source is not automatically
changed.)
OFF
Use this setting when you do not
want the signal source to be
changed automatically when the
power is turned on and "AUTO
SETUP" is running.

AUTO SIGNAL

This should normally be set to "ON".
ON
"AUTO SETUP" will be carried out
automatically when the input signal
is changed.
OFF
"AUTO SETUP" will not function
when the input signal is changed.

AUTO KEYSTN

This should normally be set to "ON".
ON
During "AUTO SETUP", the angle of
tilt of the projector is detected and
keystone distortion is corrected
automatically.
OFF
Use this setting when you do not
want automatic keystone correction
to be carried out during "AUTO
SETUP", such as when the screen
itself is at an angle.
Downloaded From projector-manual.com Panasonic Manuals
44-E
NGLISH
RGB/YP P
B R
R G B / Y P P
B R
This should normally be set to
"AUTO". RGB or YP
automatically depending on the
synchronising signal status.
When 480i, 576i, 480p, 576p,
1 080/60i, 1 080/50i, 720/60p and
some VGA480 signals are being
input, select "RGB" or "YP
accordance with the input signal.
VGA60/480p
V G A 6 0 / 4 8 0 p
Set to "VGA60" when 59.9Hz
VGA480 signals are being input
(refer to page 60 for details). Set to
"480p" when 480p RGB signals are
being input.

SXGA MODE

S X G A M O D E
This setting is only for an SXGA
signal.
SXGA
Select this item normally.
SXGA+
When the edges of the projected
image are not visible, select this
item.
A U T O
[
R G B
[
Y P P
B R
P is selected
B R
P " in
B R
4 8 0 p
[
V G A 6 0
S X G A
[
S X G A +