Table of Contents
Advertisement
2001 VOLVO Cross Country
Fitting the load carriers (accessory)
Make sure that the load carrier is pressed firmly out against the roof rail. Screw the load carrier in place.
Use the supplied torque wrench and tighten to the mark on the wrench (corresponding to 6 Nm). See
illustration.
Load carrier cover
The car's ignition key or the stud on the edge of the supplied torque wrench can be used to undo or
tighten the cover. Turn a quarter turn (90 degrees). See illustration.
http://new.volvocars.com/ownersdocs/2001/2001_XC/01xc_06a.htm (20 of 20)8/11/07 11:17 PM
Contents
|
Top of Page
Advertisement
Chapters
Table of Contents
