Listening To Radio; Selecting A Stored Station; Setting The Clock - Samsung MM-E320 User Manual

Listening to Radio

You can store up to:15 FM stations.
Press FUNCTION to select FM mode.
1.
To search
for a
station
2.
Preset
Manually
3. Se
lect the station in any of the following ways:
◆ Press the TUNING/ALBUM , or . button on
the remote control.
◆ To fast scan for a frequency manually, press
and hold the TUNING/ALBUM , or .button.
4. Press MO/ST to switch between stereo and mono.
• In a poor reception area, select MONO for a
clear, interference-free broadcast.
• This applies only when listening to an FM station.
If you don't want the preset, move back to step 3 and
5.
select a different preset.
Otherwise,
a. Press ENTER.
b. Or, press the [,] button on the top panel or
TUNING/ALBUM , or . button on the remote
control to select a program number.
c. Press ENTER to save the preset.
6. To save other radio frequency, repeat steps 2
through 5 above.
In Tuner Mode
• To scan for radio frequencies in manual mode,
use the [,] buttons on the top panel.
• To stop scanning, press STOP (@).
• To scan for a preset in preset tuning mode, use
the [,] buttons.
10
Downloaded From Disc-Player.com Samsung Manuals
English
Press TUNING MODE button
Once or more times until
...
"FM XX" is displayed.
You can search the stored
frequencies in the Preset mode.
Once or more times until
... "MANUAL" is displayed.
You can search the frequencies
one by one in the manual mode.

Selecting a Stored Station

You can listen to a stored radio station as follows:
1. Press FUNCTION to select FM mode.
2. Press the TUNING MODE button on the remote
control until "FM XX" is displayed.
3. Press [,] button on the top panel or
TUNING/ALBUM , , . on the remote
control to select a desired preset number.

Setting the Clock

For each step, you have a few seconds to set the
required options. If you exceed this time, you must
start again.
1. Switch the system on by pressing the POWER
button.
2.
Press TIMER/CLOCK button and then press the
ENTER button,"CLOCK" is displayed.
3. Press ENTER,the hour flashes.
Increase the hours:
●
Decrease the hours:
●
4. When the correct hour is displayed,
press ENTER, the minutes flashes.
Increase the minutes:
●
Decrease the minutes:
●
5. When the correct minute is displayed, press
ENTER, "TIME" appears in the display.
The current time is set now.
●
You can display the time, even when you
●
are using another function, by pressing the
TIMER/CLOCK button once.
You can also use [ or ] on the top
●
panel instead of TUNING/ALBUM ,or .
buttons in step 3,4.
.
,
.
.
,
,
.
.