Thank you for choosing Whirlpool air conditioner. Our design is based on the best efficiency and the lowest noise operation and it can keep the room comfortable. Please read this operating manual carefully before operating the unit and keep it for consultation.
Function and working temperature range. Introduction Window type room air conditioners of Whirlpool can regulate the room temperature,dry the room. It is convenient for your work,study and life. It can be widely used in residence, shop, hotel, office, library and laboratory, and so on.
Operating Condition Please operate air conditioner in the correct conditions as following. DRY mode operation COOL mode operation Outdoor temperature should be in range of 21 to 52 Outdoor temperature should be in range of 21 to 52 , otherwise it is possible for air conditioner otherwise it is possible for air conditioner to breakdown.
Page 5
How to install: Choose a location where there are no any obstacle surrounding the unit. Prepare the installation hole slightly bigger than unit size. Choose the installation space according to the following diagram. The distance of obstructions from window unit inside should be upper 300mm, lower 1500mm, left 500mm, right 500mm, front1500mm.
Installation procedure: Horizontal line 1) Remove the sticker from the front panel. 2) Put the unit into the installation hole. When installing the unit, it should be slanted down to the back to avoid the enlargement of noise or vibration. (Slant between 6-10mm.) (Shown at right figure.) The installation place should be strong enough to avoid the enlargement of noise or vibration.
Note: Drain hose or tubing can be purchased locally to satisfy your particular needs. Notes for installation Remove Before removing air conditioner to the other place, you should contact the seller firstly. Then it must be done under the direction of the professional technician.
PART IDENTIFICATION Panel outlook picture, just for reference, please take the real unit as standard. Cabinet Air inlet louver Front grille Air filter (behind the front intake grille) Power cord Control panel cover Front intake grille Air direction adjustment Vertical airflow direction vane (Airflow direction adjustment up and down).
AIR CONDITIONER OPERATION Mechanical only 3 MINUTES WAIT BEFORE RESTARTING...
Page 11
Electronic only (control panel) Note: If remote controller is lost, please open the panel and operate it by hand. And DRY mode can't be chosen by hand. AIR SWING 1 Power button Press this button to turn on the unit. Press this button again to turn off the unit. 2 Swing button Press this button to start up the auto swing function.
Remote control operation procedure Name and Function-Remote controller Note: Be sure that there are no obstructions between reciever and remote controller. D on't drop or throw the remote controller. Don't let any liquid in the remote controller and put the remote controller directly under the sunlight or any place where is very hot.
How to insert batteries 1.Remove the screw with screwdriver. 2.Remove the cover from the back of the remote control. 3.insert the two batteries (Two AAA dry - cell batteries). 4.Re - attach the cover. Remove the NOTE: cover. Don’t confuse the new and worn or different Re - attach types of batteries.
Operation Tips Operation for comfort and economy Do not overcool the room Do not let sunshine enter the Keep blind or curtains closed, temperature, this is not good for room directly when the air con- Adjust the vertical and horizontal health and waste electricity.
Caution 1) The plug must be accessible after the appliance is positioned. 2) Do not use this appliance in the laundry. 3) If the power cord is damaged, it must be replaced by the manufacture or its service agent in void of hazard. Do not use the air conditioner Do not pull out the power cord.
Care and maintenance Always turn off the air conditioner and main power supply before cleaning to ensure safety. Clean unit Air filter The air filter behind the intake grille should be washed at least 1. Clean surface panel with a soft every two weeks or as often as it needs cleaning.
Trouble shooting guide Please check the following items before asking for repair,it saves your time and money. Fault phenomenon Trouble-shooting * Is there a power failure? * Is the plug out? Air conditioner dose not * Is power fuse or switch off ? operate at all.
*Carelessly splash water or something into air conditioner; *Electrical lines are much hot or lines cover breaks; *Other strange situations. After service If your air conditioner has the questions of quality or anything else, please contact the service center of Whirlpool.