42 WHC/AQUASMART
Changeover sensor installation
Material supplied
Changeover sensor mounting
Changeover sensor installation instructions
The changeover sensor is electrically connected in the unit
electric box.
During installation, the changeover sensor
located on the water inlet pipe, using the sensor holder clip
and nylon clamps
, after removing the existing insulation.
Water inlet
Water outlet
has to be
When the operation shown in the figure is finished, wrap the
whole with the adhesive insulation
Note:
Make certain that changeover sensor is located on the primary
circuit (water-side before the valve).
E N G L I S H
Changeover sensor
Sensor holder clip
or spring
Nylon clamps
Adhesive insulation
.
GB - 9