Depth Adjustment; Operation - Makita HR2432 Instruction Manual

NOTE:
At some angles of the side grip with the tool, the
•
dust extractor attachment cannot be installed on
the tool because of the interference between the
attachment and the tool.
Insert firmly the hose of the dust extractor attachment
into the hose port of the tool until the hose hits against
the bottom of the port to be fixed firmly to the tool.
1
005881
Installing dust bag
1
2
005882
Keeping the angle of the dust bag with the tool at 90°,
insert the dust bag into the dust exhaust port of the tool.
Secure the dust bag by turning it clockwise at its frame.
Adjusting the position of dust extractor
attachment
1
005883
Loosen the clamp screw of the dust extractor attachment
by turning it counterclockwise.
And then align the tip of the bit with the top of the dust
extractor attachment.
1. Hose
2. Hose port
2
1. Dust exhaust
port
2. Frame
1. Bit
2. Clamping screw
2
1
005884
Tighten the clamp screw by turning it clockwise to
secure the dust extractor attachment.

Depth adjustment

2
005885
Loosen the screw of the stopper by turning it
counterclockwise so that the stopper could slide on the
depth gauge of the dust extractor attachment. Slide the
stopper to the desired drilling depth of the gauge, and
then tighten the screw by turning it clockwise.

OPERATION

Drilling with dust extractor attachment
1
005886
In drilling operation, hold the tool so that the top end of
the dust extractor attachment is always kept in complete
contact with the surface of concrete.
NOTE:
Any space between them would result in a
•
considerable loss of dust extracting power.
8
1. Clamping screw
1. Stopper
2. Drilling depth
1
1. Complete
contact with the
surface