Vacuum Motor - Chariot CV28 Operating Instructions Manual

MAINTENANCE-VACUUM MOTOR
machine. Only qualified personnel should work
inside machine. Always wear eye protection and
protective clothing when working on or near
batteries. Avoid skin contact with the acid
contained in the batteries.
VACUUM MOTOR CARBON BRUSH
REPLACEMENT
Remove rear cover from machine.
Remove batteries from machine.
Remove 4 bolts holding access cover in place and
remove cover.
Pull top clips from vacuum motor top brush retainers.
Remove and inspect brushes.
Replace both if either is less than 3/8" (9.5 mm)
long.
Reverse steps to assemble.
4-11
Disconnect batteries
before working on
86037810 CHARIOT® VACUUM 12/16/06
TO REMOVE VACUUM MOTOR
Remove rear cover.
Remove two screws from top of control panel and
four screws from side of control panel housing.
Slide control housing back from tank to expose main
cover bolts.
Remove four bolts in front of console from cover,
and 2 bolts from the bottom front of main cover, and
two inside, next to batteries.
Remove main cover.
Remove four bolts from vacuum motor and
disconnect plug.
Reverse steps to assemble.