Chariot CV28 Operating Instructions Manual page 26

MAINTENANCE-BRUSH DECK
BRUSH DECK
The dual cylindrical head is designed to agitate the
carpet while vacuuming. The first scrubbing brush
turns in a clockwise rotation when viewed from the
right of operator's side of machine. The first brush
scrubs dirt and debris between the brushes. The
second brush, turns in a counter clockwise rotation,
picks up debris and throws it into the nozzle.
MAINTENANCE
The brushes should wear evenly side to side.
Brushes should be replaced as a set when bristle
length wears to height of yellow PerformAlert
bristles.
4-7
TM
86037810 CHARIOT® VACUUM 08/20/07
BRUSH REMOVAL
The brushes are removed from the right side of the
machine.
1. Remove right deck side cover by removing the
two mounting screws.
2. Remove the brush door by removing the three
mounting screws.
3. Slide the brushed out the side opening.
BRUSH INSTALLATION
The front and rear brush are opposite in brush
pattern and must be installed in the correct
orientation.
1. Slide brush through door opening and onto drive
shaft. Make sure it is fully seated and is driven
by the deck system.
2. Install the brush door and deck side cover.