Table of Contents
Advertisement
Ultima Operators Manual
Solution
STAY Indicator
The STAY indicator is used to display that the system is Set in STAY Mode 1 or STAY
Mode 2. The STAY indicator will also flash in unison with the AWAY indicator when
programming various options throughout the operator's manual.
Refer to page 11 for information on the different methods of setting in STAY Mode 1. For
information and the method of setting in STAY Mode 2, refer to page 12.
Flashing Twice A Second
Flashing Once Every
System Unset
This indicator will display with the
MAINS Indicator
The MAINS indicator is used to display that the systems AC mains supply is normal or has
failed.
Off Indicator / Zone Closed
The
zone becomes Open during the Unset state. The indicator will stop flashing when all zones
are Closed.
On Indicator / Zone In Alarm
The
an alarm occurs. The indicator will reset once a valid user code has been entered.
Detection Systems
STAY Indicator
On
Off
3 Seconds
MAINS Indicator
On
Flashing
indicator will display when the system is in the Unset state and will flash when a
indicator will display when the system is Set in AWAY Mode and will flash when
System Is Set In STAY Mode 1 Or STAY Mode 2
System Is Not Set In STAY Mode 1 Or STAY Mode 2
Zone Omitting Mode Or Setting STAY Mode 2 Zones
Day Alarm Status – Day Alarm Turned On
Table 3: STAY Indicator
indicator when the system has been Unset.
AC Mains Power Normal
AC Mains Supply Has Failed
Table 4: MAINS Indicator
Definition
Definition
Operators Manual UK
9
Advertisement
Table of Contents
