Setting The System; Forced Setting; Setting In Away Mode - Detection Systems solution ultima Operator's Manual

Ultima Operators Manual
Solution

Setting the System

There are several different ways to Set the system depending on whether you are leaving the
premises and require all active zones to be in a ready state for an intruder, or, if you are
remaining in the premises and only require part of the system to be in a ready state for an
intruder.
If a zone is not Closed at the end of exit time, the zone will be automatically omitted and will
be constantly displayed on the Keypad. The zone will again become an active part of the
system when the zone has restored (i.e. If a window is left open after exit time has expired,
the window will not be an active part of the system until the window has closed. Opening
the window after exit time has expired will cause an alarm condition).
The different methods for setting the system include:
Ø
Ø
Ø

Forced Setting

The feature of setting the system when a zone is not Closed is known as forced setting. If
the system does not set and a long beep is heard, forced setting is not permitted. If this is the
case, you must ensure that all zones are Closed or manually omitted before you can Set the
system. Refer to Omitting Zones on page 16 for more information.

Setting In AWAY Mode

When you leave your premises and require all zones to be in a ready state to detect intrusion,
you would set the system in AWAY Mode.
There are two different methods for setting the system in AWAY Mode. Method one is
standard and will always operate. Method two is optional and may be disabled by your
Engineer if you do not wish to use single button setting.
Method One
How To Set The System In AWAY Mode
1.
Method Two
How To Set The System In AWAY Mode
1.
Detection Systems
AWAY Mode (Full Set)
Set the entire system. Refer to Setting In AWAY Mode on page 10.
STAY Mode 1 (Part Set 1)
Set all zones except those programmed to be automatically omitted by the Engineer.
Refer to Setting In STAY Mode 1 on page 11.
STAY Mode 2 (Part Set 2)
Set all zones except those programmed to be automatically omitted by the Master
Code holder. Refer to Setting In STAY Mode 2 on page 12.
Enter your user code followed by the # button (eg. 2580#).
Two beeps will be heard and the AWAY indicator will display. Exit time will now
commence counting.
Hold down the # button until two beeps are heard.
The AWAY indicator will display and exit time will commence counting.
11
Operators Manual UK