Operation - Nevir NVR-4003CF Instruction Manual

feed table and the piece holder in position unless this is not possible duo to size or shape of the
food.
5. To protect against any risk of electrical shock, do not put power unit in water or other liquid.
6. Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions,
or is dropped or damaged in any manner. Return appliance to the place of purchase for
replacement or repair.
7. The use of attachments not recommended or sold by the appliance manufacturer may cause
fire, electric shock or injury.
8. Do not use the appliance outdoors.
9. Do not let cord hang over edge of table or counter or touch hot surface.
10. Blade is sharp. Hold only by blade lock. Handle carefully when cleaning.
11. Do not use the appliance for other than its intended use.
PREPARING TO SLICE
1. Unwrap cord from bottom of slicer, and slide into slot. Position slicer on a clean, dry and
smooth surface.
2. Move the sliding feed table back and forth a few time to make sure movement.
3. Place the piece holder on back of the sliding feed table.
4. Select the required slice thickness by turning thickness adjusting knob, clockwise for thinner
slice and counter-clockwise for thicker slice. The range of thickness adjusting is from 0 to
15mm.

OPERATION

CAUTION: ALWAYS USE FOOD PLATEAU SUPPORT AND FOOD PUSHER
1. Plug into 220-230VAC50Hz outlet.
2. Place food to be sliced on the sliding feed table and press the piece holder against thickness
guide. Then pull the sliding feed table against the blade by hand.
3. The maximum size of food is:110x110x90(mm)(length x width x thick).
4. Switch on the appliance.
5. When the blade is rotating, push the sliding feed table toward blade. Move tray back and forth
steadily. Keep food gently pressed against guide for even slicer.
Thickness Adjusting Knob
(fig.2)
2