D-Link DIR-816L User Manual page 120

DIR-816L Wireless AC750 Dual Band Router & Access Point
with 3G/CDMA/LTE Support and USB Port
User Manual
Parameter
PPP IP extension
Static IP Address
PPP debug
Figure 97. The page for creating a new
Parameter
Isolate connection
Enable RIP
Enable IGMP Multicast
NAT
Firewall
Ping
When all needed settings are configured, click the Apply button.
This option is used by some ISPs. Contact your ISP to clarify if this
checkbox needs to be enabled.
Fill in the field if you want to use a static IP address to access the
Internet.
Select the checkbox if you want to log
debugging.
PPPoE + Static IP
Miscellaneous (for PPP section)
When the checkbox is selected, the router uses an alternate routing
table for this connection. Select the checkbox only when your ISP
requires this.
Select the checkbox to allow using RIP for this connection.
Select the checkbox to allow multicast traffic from the external
network (e.g. video streaming) to be received.
Select the checkbox if you want one WAN IP address to be used for
all computers of your LAN.
Select the checkbox to enable protection against ARP and DDoS
attacks.
Select the checkbox to allow the router to answer ping requests from
the external network through this connection. For security reasons,
it is recommended not to select this checkbox.
Page 120 of 304
Configuring Device (Router Mode)
Description
all data on PPP connection
connection. The Miscellaneous section.
Description