Olympus CAMEDIA D-460ZOOM Instructions Manual page 6

Radio and Television Interference
Change or modifications not expressly approved by the manufacturer may
void the user's authority to operate this equipment. This equipment has been
tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the distance between the camera and receiver.
• Connect the equipment to an outlet on a circuit different from that to which
the receiver is connected.
Only the included RS-232C serial cable should be used to connect the
camera to a personal computer (PC).
Declaration of Conformity
Model Number: D-460ZOOM
Trade Name:
Responsible party:
Address:
Telephone number: 516-844-5000
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
This Class B digital apparatus meets all requirements of the Canadian
Interference-Causing Equipment Regulations.
6
OLYMPUS
Olympus America Inc.
2 Corporate Center Drive, Melville, New York 11747-3157
U.S.A.