Installation; Bench Mounting - Makita LS1040F Instruction Manual

43. Take care when slotting.
44. Some dust created from operation contains
chemicals known to cause cancer, birth
defects or other reproductive harm. Some
examples of these chemicals are:
lead from lead-based-painted material and,
•
arsenic
•
chemically-treated lumber.
Your risk from
depending on how often you do this type of
work. To reduce your exposure to these
chemicals: work in a well ventilated area and
work with approved safety equipment, such as
those dust masks that are specially designed
to filter out microscopic particles.
45. To reduce the emitted noise, always be sure
that the blade is sharp and clean.
46. The operator is adequately trained in the use,
adjustment and operation of the machine.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity with product (gained
from repeated use) replace strict adherence to safety
rules for the subject product. MISUSE or failure to
follow the safety rules stated in this instruction
manual may cause serious personal injury.

INSTALLATION

Installing auxiliary plate
2
3
012658
1 2
3 4
001832
Installing the auxiliary plate using the notch in the tool's
base and secure it by tightening the hex bolt.
and chromium
these exposures
1. Auxiliary plate
2. Hex bolt
1
3. Base
1. Auxiliary plate
2. Base
3. Hex bolt
4. Nut
Installing the holders
from
varies,
012653
012652
Install the holders on both sides of the base and secure
them with screws.
Adjust the adjusters so that they contact the floor surface.
NOTE:
In some countries, the holders may not have feet.

Bench mounting

When the tool is shipped, the handle is locked in the lowered
position by the stopper pin. Release the stopper pin by
lowering the handle slightly and pulling the stopper pin.
001792
This tool should be bolted with two bolts to a level and stable
surface using the bolt holes provided in the tool's base. This
will help prevent tipping and possible personal injury.
001856
6
1. Holder
1
1. Holder
2. Adjuster
1
3. Screw
2
3
1. Stopper pin
1
1. Bolt
1