Inserting Remote Control Batteries; Viewing The Various Functions On Your System; Setting The Clock - Samsung MAX-L42 Instruction Manual

Inserting Remote Control Batteries

Insert or replace remote control batteries when you:
Purchase the mini-compact system
Find that the remote control is no longer operating correctly
When replacing the batteries, use a new set of batteries and
never mix alkaline and manganese batteries.
1
Place your thumb on the position marked
partment cover (rear of the remote control) and push the cover in the
direction of the arrow.
2
Insert two AAA, LR03 or equivalent batteries, taking care to respect
the polarities:
+ on the battery against + on the remote control
– on the battery against - on the remote control
3
Replace the cover by sliding it back until it clicks into position.
Viewing the Various Functions on
Your System
You can view the various functions available on your system.
1
Press the Demo button.
Result: The various functions available are listed in turn on the dis-
play.
All these functions are described in detail in this booklet.
For instructions on how to use them, refer to the appropriate
sections.
2
To cancel this function, press Demo again.
Downloaded From Disc-Player.com Samsung Manuals

Setting the Clock

Your system is equipped with a clock which allows you to
turn your system on and off automatically. You should set the
clock:
When you purchase the mini-compact system
After a power failure
After unplugging the unit
on the battery com-
1
2
3
4
5
6
7
Remember to reset the time when the clock changes from
winter to summer time and vice verse.
For each step, you have a few seconds to set the required
options. If you exceed this time, you must start again.
Switch the system on by pressing On/Standby.
Press Timer/Clock twice.
Result: CLOCK is displayed.
Press Enter.
Result: The hour flashes.
To... Turn the Multi Jog knob to the...
Increase the hours Right
Decrease the hours Left
When the correct hour is displayed, press Enter.
Result: The minutes flash.
To... Turn the Multi Jog knob to the...
Increase the minutes Right
Decrease the minutes Left
When the correct time is displayed, press Enter.
Result: The clock starts and is displayed, even when the system is in
standby mode.
You can display the time, even when you are using another
function, by pressing Timer/Clock once.
You can also use Program/Set button on the remote control
to instead Enter button in step 3,5,7.
You can also use / buttons to instead Multi Jog
knob in step 4,6.
4,6
1
4,6
2
4,6
3,5,7
GB