Where To Install Your Micro Component System; Connecting Your System To The Power Supply; Inserting Remote Control Batteries - Samsung MM-VB7 Instruction Manual

Where to Install Your
Micro Component System
To take full advantage of your new micro component system,
follow these installation instructions before connecting the unit.
Install the system on a flat, stable surface.
Never place this unit on carpeting.
Never place this unit in an outdoor area.
Maintain an open space of approximately 6 inches (15 cm) on the
sides and rear of the system, for ventilation purposes.
Make sure that you have enough room to open the compact disc
compartment easily.
Place the loudspeakers at a reasonable distance on either side of
the system to ensure good stereo sound.
Direct the loudspeakers towards the listening area.
For optimum performance, make sure that both speakers are placed
at an equal distance above the floor.
TUNER
Standby/On Band
Previous
VCD/CD
TAPE
Phones
AUX
REC/Pause
Full Auto Remote Control Operation
Connecting your System to the
Power Supply
The main lead must be plugged into an appropriate socket.
Before plugging your system into a main socket, you must check
the voltage.
1
Check the position of the voltage selector on the rear panel
(OPTIONAL).
2
Plug the main lead (marked AC Cord on the rear of the system) into
an appropriate socket.
3
Press the Standby/On button to switch your mini-compact system on.
Open/Close
Tuning Next
Mode
Down Up
Demo
Volume
Mic
Sound
REV.Mode Mode
Push Eject Push Eject

Inserting Remote Control Batteries

Insert or replace remote control batteries when you:
Purchase the micro component system
Find that the remote control is no longer operating correctly
When replacing the batteries, use a new set of batteries and
never mix alkaline and manganese batteries.
1
Place your thumb on the position marked
compartment cover (rear of the remote control) and push the cover in
the direction of the arrow.
2
Insert two AA, R6 or equivalent batteries, taking care to respect the
polarities:
+ on the battery against + in the battery compartment
– on the battery against – in the battery compartment
3
Replace the cover by sliding it back until it clicks into position.
If you will not be using the remote control for a long time,
remove the batteries to prevent corrosion.
GB
on the battery
7