Seagate ST3000DM001 Product Manual page 10

www.seagate.com
Table 1 Drive specifications summary for 3TB, 2TB, 1.5TB, 1TB and 750GB models (continued)
Drive Specification*
Ambient temperature
Temperature gradient
Relative humidity
Relative humidity gradient (max)
Wet bulb temperature (max)
Altitude, operating
Altitude, non-operating
(below mean sea level, max)
Operational shock (max)
Non-operational shock (max)
Vibration, operating
Vibration, non-operating
Drive acoustics, sound power
Idle***
Seek
Non-recoverable read errors
Annualized Failure Rate (AFR)
Rated Workload
Warranty
Load/Unload cycles (25°C, 50% rel. humidity)
Supports Hotplug operation per the
Serial ATA Revision 3.2 specification
*All specifications above are based on native configurations.
** One GB equals one billion bytes and 1TB equals one trillion bytes when referring to hard drive capacity. Accessible capacity may vary depending on operating environment
and formatting.
* ** During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and power to operational levels.
Seagate Desktop HDD Product Manual, Rev. P
ST3000DM001 &
ST3000DM002;
ST2000DM001
30°C per hour max (non-operating)
300 Gs at 2ms
2Hz to 22Hz: 0.25 Gs, Limited displacement
2.4 bels (typical)
2.6 bels (max)
2.6 bels (typical)
2.7 bels (max)
Average annualized workload rating: <55 TB/year.
The AFR specification for the product assumes the I/O workload does not exceed the average
annualized workload rate limit of 55 TB/year. Workloads exceeding the annualized rate may
degrade the product AFR and impact reliability as experienced by the particular application. The
average annualized workload rate limit is in units of TB per calendar year.
To determine the warranty for a specific drive, use a web browser to access the following web
page: http://www.seagate.com/support/warranty-and-replacements/
From this page, click on "Check to see if the drive is under Warranty". Users will be asked to provide
the drive serial number, model number (or part number) and country of purchase. The system will
display the warranty information for the drive.
ST2000DM001 &
ST2000DM002;
ST1500DM003
0° to 60°C (operating)
–40° to 70°C (non-operating)
20°C per hour max (operating)
5% to 95% (operating)
5% to 95% (non-operating)
30% per hour
37.7°C max (operating)
40.0°C max (non-operating)
–304.8m to 3048m
(–1000 ft to 10,000+ ft)
–304.8m to 12,192m
(–1000 ft to 40,000+ ft)
80 Gs at 2ms
22Hz to 350Hz: 0.50 Gs
350Hz to 500Hz: 0.25 Gs
5Hz to 22Hz: 3.0 Gs
22Hz to 350Hz: 3.0 Gs
350Hz to 500Hz: 3.0 Gs
14
1 per 10 bits read
<1.0% based on 2400 POH
300,000
Yes
Drive Specifications
ST1000DM003 &
ST1000DM004;
ST750DM003
350 Gs at 2ms
2.2 bels (typical)
2.4 bels (max)
2.4 bels (typical)
2.5 bels (max)
9