Canon mvx1sI Instruction Manual page 126

Problem
"REMOVE THE CASSETTE"
appears on the screen.
"SET THE TIME ZONE,
DATE AND TIME" appears on
the screen.
The wireless controller will not
work.
Recording on the Tape
Problem
Image will not appear on the
screen.
Pressing the start/stop button
will not start recording.
Sound is distorted.
Sound is recorded in a lower
level than the actual level.
Playback of the Tape
Problem
During playback there is
video noise.
Pressing the playback button
does not start playback.
Image will not appear on the
TV screen.
Tape is running, but image will
not appear on the TV screen.
No sound from the built-in
speaker.
The tape stops during
playback pause.
Downloaded From VideoCamera-Manual.com Manuals
126
Unload and reload the cassette.
Set the time zone, date and time.
Recharge the built-in lithium battery and set the time zone,
date and time.
Set [WL.REMOTE] to [ON].
The battery of the wireless controller is exhausted. Replace
the battery.
Set the power switch to CAMERA.
Open the lens cover.
Set the power switch to CAMERA.
Load a cassette.
Tape reached the end ("
Rewind the tape or replace the cassette.
Cassette is protected ("
the position of the protect switch.
When recording near loud sounds (such as fireworks, drums
or concerts), sound may become distorted. Sound may be
recorded properly when you set [MIC ATT] to [ON] in the
menu, or when you adjust the audio recording level manually.
When recording near loud sounds (such as fireworks, drums
or concerts), sound may be recorded not in the actual sound
level. Sound may be recorded properly when you adjust the
audio recording level manually.
Set [MIC ATT] to [OFF] in the menu.
Video heads are dirty. Clean the video heads.
Set the power switch to PLAY.
Load a cassette.
Tape reached the end ("
Rewind the tape.
Set [AV DV] to [OFF].
Check again the camcorder is properly connected to the TV.
TV/VIDEO selector on the TV is not set to VIDEO. Set the
selector to VIDEO.
Video heads are dirty. Clean the video heads.
You attempted to play back or dub copyright protected tape.
Stop playback/dubbing.
Speaker volume is turned off. Adjust the volume with the SET
dial.
When playback pause continues for more than 4 minutes 30
seconds during playback or audio dubbing, the camcorder
shuts off to protect tape and video heads. Playback the tape
again and press the
Solution
Solution
END" flashes on the screen).
" flashes on the screen). Change
Solution
END" flashes on the screen).
/ pause button.
17
23
23
134
66
20
25
25
17
17
133
68
68
65
136
34
17
34
64
38
38
136
–
37
–