Getting To Know Your Appliance; The Control Panel; The Hotplates - Bosch PKV9..DC1 series Instruction Manual

*Getting to know your
appliance
The instruction manual is the same for various different
y o u r a p p l i a n c e G e t t i n g t o k n o w
hobs. You can find the hob dimensions in the overview
of models. ~ Page 2

The control panel

Display
Heat settings
‚ - Š
Residual heat
• / œ
Keep warm function
–©
Timer
‰‰
Controls with illuminated bars above the symbols
Main switch
#
Childproof lock
> Š
Wipe protection
Keep warm function
Û
Settings range
1 û 2 û 3 û 4 û
Sensor frying system
é
Automatic zone control
ö
Kitchen timer
t
Timer
y
Stopwatch function
x
Controls without illuminated bars above the symbols
Hotplate selection
ä
Notes
Depending on the operating condition of the hob the
■
controls which can currently be selected light up
brightly or dimmed. If you touch them, the relevant
function is activated.
The controls which cannot currently be selected do
■
not light up.

Getting to know your appliance

Always keep the controls dry. Moisture reduces their
■
effectiveness.
Do not pull pans close to the displays and sensors.
■
The electronics could overheat.

The hotplates

Hotplate Activating and deactivating
Single-circuit hot-
$
plate
Dual-circuit hotplate
ð Touch the
Tri-circuit hotplate
ò Touch the
circuit is activated
Touch the
ment circuit is activated
When the hotplate is activated: the corresponding indicator lights up
Notes
Any dark areas in the glow pattern of the hotplate
■
are due to technical reasons. The function of the
hotplate is not affected.
Hotplate temperature is regulated by the heat
■
switching on and off. The heat may also switch on
and off at the highest setting.
With multi-circuit hotplates the heater elements of the
■
inner filament circuits and the heater element of the
activations may switch on and off at different times.
â Hotplates with bridge heating element
Two individual hotplates can be interconnected with a
bridge heating element to create one large extended
cooking zone.
Under normal operation these hotplates both work as
normal single-circuit and dual-circuit hotplates.
en
ö symbol
ö symbol; the 2nd filament
ö symbol again; the 3rd fila-
5