Terminal Communication - impro XEC900 Installation Manual

RS485 1 (Controller) Port (Continued)
Data Format ...........................
Communications Protocol ......
Line Termination ....................
Default Mode ..........................

Terminal Communication

RS485 2 (Terminal) Port
Configuration ..........................
Electrical Interface .................
Baud Rates ............................
Data Format ...........................
Communications Protocol ......
Line Termination ....................
Default Mode ..........................
General
Memory
RAM (Non-volatile) .................
Flash ROM .............................
Diagnostic LED Indicators
Power-on LED ........................
Incoming RS485 1 (Controller)
Outgoing RS485 1 (Controller)
Incoming RS485 2 (Terminal) ..
Outgoing RS485 2 (Terminal) ..
Link Speed LED (Ethernet) ....
Duplex Mode LED (Ethernet) .
Link Active LED (Ethernet) .....
CPU Usage ............................
CPU Running .........................
CPU Fault ..............................
XEC300-0-0-GB-09
8 data bits, no parity, 1 stop bit.
Impro Secure Communications Protocol.
Provision is made for line termination.
Receive Mode.
38 400 Default.
RS485.
9 600, 19 200, 28 800, 38 400, 57 600 and
76 800 selectable via the Protocol.
8 data bits, no parity, 1 stop bit.
Impro Secure Communications Protocol.
Provision is made for line termination.
Receive Mode.
64 MBytes.
8 MBytes.
Red LED (internally visible).
Flashing Green LED (internally visible).
Flashing Red LED (internally visible).
Flashing Green LED (internally visible).
Flashing Red LED (internally visible).
Flashing Red LED (internally visible).
Flashing Red LED (internally visible).
Flashing Red LED (internally visible).
Red LED (internally visible).
On = Idle, Off = Busy.
Red LED (internally visible).
On = Yes, Off = No.
Red LED (internally visible).
On = Fault Condition, Off = Ok.
Blank Space
September 2015 Page 3