Controller Communication - impro XEC900 Installation Manual

Devices with a high in-rush current demand, such as certain maglocks and
other electromechanical devices, can momentarily draw more than 3 A. The
Power Supply then effectively shuts down as directed by its built in
protection as exceeding the 3 A rating is considered a short-circuit.
Overcome this by installing the recommended 12 V 7 Ahr Battery to help
supplement the in-rush current such a device may draw on activation.
Power Input
Input Voltage
Power Output
Output Voltage
(Mains Power On)
Output Current
System Battery
Type .......................................
Approximate Length ...............
Approximate Width .................
Approximate Height ................
The following specifications are common to both the Aluminium Extruded Cabinet and
the Power Supply Combo:
Real Time Clock (RTC) Backup
Battery
Battery Type ...................
Battery Life .....................

Controller Communication

Ethernet Port
Connection .............................
Protocol ..................................
The RS485 1 (Controller) Port connection details only apply to Impro EC
NOTE:
Controllers with Firmware V7.16 upwards.
RS485 1 (Controller) Port
Configuration ..........................
Electrical Interface .................
Baud Rates ............................
XEC300-0-0-GB-09
85 V AC to 265 V AC at 50/60 Hz.
13.8 V DC ±0.3 V DC.
2 A continuous (Power Output Terminals).
6 V 3 Ahr (Max) Sealed Lead Acid Battery.
151 mm (6 in) (Max).
65 mm (3 in) (Max).
99 mm (4 in) (Max) including the terminals.
1 x 3 V, CR2032, Lithium cell Battery.
2 Years with power OFF,
5 years with power ON,
5 years storage with Battery Tab in place.
Standard Ethernet RJ45 connector.
10/100/1 000 Mbps, half or full duplex.
NOTE: The Impro ECII is rated to 100
MBps, however the Controller will
work on a 1 000 MBps (1 GB)
network.
TCP/IP, UDP.
38 400 Default.
RS485.
9 600, 19 200, 28 800, 38 400 and 57 600
selectable via the Communications Protocol.
September 2015
II
Page 2