Table of Contents
Advertisement
ENGLISH
Replace the carbon brush (Fig. D)
Lubrication
•
Regularly replace and inspect the carbon brush. Once
completely worn out by continuous wear and tear, it will
have to be replaced. Must keep carbon brush clean and
sliding freely within the brush holder. Both carbon
brushes have to be replaced at the same time.
•
Remove the fixed screws (9) on the carbon brush to
remove the carbon brush (10) and brush holder.
•
Remove the coil spring supporting the carbon brush (11)
in the brush holder, and insert a new carbon brush that
meets the specifications.
•
Set up the brush holder again and return the supporting
coil spring to its original position.
Cleaning
Warning! Blow dirt and dust out of the main
housing with dry air as often as dirt is seen
collecting in and around the air vents. Wear
approved eye protection and approved dust mask when
performing this procedure.
Warning! Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the
material of the parts. Use only mild soap and damp cloth to
clean the tool. Never let any liquid get inside the tool; never
immerse any part of the tool into liquid.
8
Technical data
Rotary hammer
Power input
W
Voltage
V
Frequency
Hz
No-load speed
/min
Impact rate
BPM
Impact energy
Modes
Max drilling capacity
Concrete
mm
Steel
mm
Wood
mm
Weight
kg
BPHR202
620
220-240
50/60
0-1250
0-3900
J
1.34
2
20
13
25
2.6
Advertisement
Table of Contents
