Table of Contents
Advertisement
Warning! When the drill bit hits cement or the
steel rebar in the cement, the tool may recoil
dangerously. Please hold the tool tightly in a
balanced and stable position at all times to prevent it from
recoiling dangerously.
Overload coupling device
If the drill bit his caught or hooked, the driving force
transmitted to the drill shaft will be cut off. This would
generate a strong recoil, so it would be necessary to hold
the tool tightly with both hands to remain in a stable position.
Setting the drilling depth (Fig. E)
The depth stop is a convenient feature to ensure uniformity
in drilling depth. Loosen the side handle to adjust the depth
gauge according to the required depth. After that, tighten the
side handle.
•
Slacken the side handle (5) by turning the grip
counterclockwise.
•
Set the depth stop (6) to the required position. The
maximum drilling depth is equal to the distance between
the tip of the drill bit and the front end of the depth stop.
•
Tighten the side handle by turning the grip clockwise.
Switching on and off
Warning! Before plugging in to the power source, make
sure the switch can be flipped freely, and can return to its
original position once released.
•
To switch the tool on, press the variable speed switch
(1). The tool speed depends on how far you press the
switch.
•
As a general rule, use low speeds for large diameter drill
bits and high speeds for smaller diameter drill bits.
•
For continuous operation, press the lock-on button (2)
and elease the variable speed switch.
•
To switch the tool off, release the variable speed switch.
To switch the tool off when in continuous operation, press
the variable speed switch once more and release it.
Accessories
The performance of your tool depends on the accessory
used. Black and Decker accessories are engineered to high
quality standards and designed to enhance the performance
of your tool. By using these accessories you will get the very
best from your tool.
Maintenance
Your Black and Decker corded/cordless appliance/tool has
been designed to operate over a long period of time with a
minimum of maintenance. To ensure satisfactory operations,
the tool must be maintained and cleaned regularly
Warning! Before performing any maintenance on corded/
cordless power tools:
•
Switch off and unplug the appliance/tool.
•
Or switch off and remove the battery from the appliance/
tool if the appliance/tool has a separate battery pack.
•
Or run the battery down completely if it is integral and
then switch off.
•
Unplug the charger before cleaning it. Your charger does
not require any maintenance apart from regular cleaning.
•
Regularly clean the ventilation slots in your
appliance/tool/ charger using a soft brush or dry cloth.
•
Regularly clean the motor housing using a damp cloth.
Do not use any abrasive or solvent-based cleaner.
•
Regularly open the chuck and tap it to remove any dust
from the interior (when fitted).
ENGLISH
ENGLISH
7
3
Advertisement
Table of Contents
