Engine, Oil & Coolant - TATA Motors nano emax Owner's Manual

ENGINE OIL & ENGINE COOLANT
ENGINE OIL LEVEL
2
1
1. Engine Filling Cap
Engine oil level should be checked
when engine is cold. Allow at least
30 mins. for engine oil to settle
before checking oil level.
1. For checking engine oil level,
pull out the dipstick from the
engine oil case, wipe it clean with
a cloth or a paper napkin.
2. Insert it again to its original
position.
3. Pull out the dipstick again and
observe the oil level on the
dipstick.
4. If the oil level is below the mid
point of min. and max. marks, top
up using recommended grade
of oil.
NOTICE
Oil level should not exceed the
max. Mark. Always check the oil
level when the car is on a level
ground and the engine in cold
condition.
Check the engine oil level if "low oil
pressure" warning comes 'ON'
while driving. Failure to check the
oil level regularly could lead to
serious trouble due to insufficient
oil.
ENGINE OIL TOP-UP
Remove the oil filler cap and pour
oil slowly through the filler hole to
bring the oil level to the upper limit
on the dipstick. Be careful not to
overfill. Too much oil is almost as
bad as too little oil. After refilling, start
the engine and allow it to idle for
about a minute. Stop the engine; let
2. Dip Stick
the oil settle and check oil level
again.
ENGINE COOLANT LEVEL
The coolant level in the coolant no-
loss tank should be between max.
& min. marks. This can be viewed
through a translucent reservoir. If
less, add coolant up to the max.
mark and refit the cap properly.
Check coolant level in the radiator,
by opening the pressure cap
(ensure vehicle is in cold condition).
If coolant level is seen below filler
neck top, then add specified
pre-mixed coolant (50:50).
MAINTENANCE
NOTICE
89