Lubrication - EGO LM2100SP Operator's Manual

LUBRICATION

Lubricate with light oil as directed
below at least once each season.
◾ ◾
Periodically lubricate the spring
and pivot pin in the quick-adjust
lever, the torsion spring and
pivot of the rear-discharge door
with light oil to prevent rust (Fig.
32a & 32b).
◾ ◾
Place the mower into the locked
storage position:
1. Move the cutting-height
adjustment lever toward the
front and engage it in the lowest setting (setting 1).
2. Open the handle-locking clamps and fully recess the
side rails to the compact position.
3. Press and hold the quick-adjust lever with your right
hand to release the handle.
4. Gently pivot the handle toward the front of the mower;
release the quick-adjust lever and continue to pivot the
handle until you hear and feel the lock pin engage in
the locked storage position.
◾ ◾
Place the folded mower upright on the ground
(Fig. 32c &32d).
◾ ◾
Lubricate the deck-height adjustment joint.
◾ ◾
For LM2100SP, lubricate the bearings on the drive shaft
near the rear wheels and the bearings in the front wheels
(Fig. 32c).
◾ ◾
For LM2100, lubricate the bearings in both the rear and
front wheels (Fig. 32d).
32a
Spring
Pivot Pin
56-VOLT LITHIUM-ION CORDLESS LAWN MOWER — LM2100SP & LM2100
32b
32c
Bearing
Drive shaft
Bearing
For LM2100SP
32d
Bearing
Bearing
For LM2100
Pivot
Torsion Spring
Bearing
Deck-Height
Adjustment Joint
Bearing
Bearing
Deck-Height
Adjustment Joint
Bearing
29