Oki OKIPOS 425S Developer's Manual page 72

5.7.5.1.2 Paper Quality
The paper in the following quality may be used.
A25025.doc
Type
Single-part paper and Stub
Multi-part paper
1 Paper smoothness must be 90 ~ 7 sec. for Beek and 75 ~ 300 sec. for Sheffield.
2 If you use paper other than that specified, test it to verify that it prints without problems.
5.7.5.1.3 Paper Weight and Maximum Duplicating Quantity
The weight of paper usable for printing and max. duplicating quantity are shown in the table below.
A25026.doc
Type Paper Quality
Single- High quality
part paper paper
Stub High quality
paper
Multi-part Pressure-
Paper sensitive paper,
Carbon-lined
paper
5.7.5.1.4 Fixing Method of Multi-part Paper Joint
1 The multi-part paper joint shall be fixed with 1mm line-pasting on the edge which is first fed into the printer.
2 The joint must be glued securely and pressed without fail to prevent any part from lifting.
3 Paste shall not overflow the paper edge.
4 Any distinct wrinkle must not be observed in the pasting area.
OP425_14.eps
1
1 Pasted firmly (Width: 1mm)
2 Paper inserting direction
|
OKIPOS 425S
72
Paper Quality
High quality paper
Pressure-sensitive paper, Carbon-lined paper
Weight
2
52~105 g/m (14~28 lb)
2
65~81 g/m (17~21 lb)
2
65~81 g/m (17~21 lb)
2
34~40 g/m (9~11 lb)
2
Max.
Copies
-
Slip
Validation
-
5 copies
(original +
4 copies)
Total Paper
Thickness
-
-
0.30mm or
less