Oki PAGE 14ex User Manual page 26

Oki printer user's guide
Table of Contents

Advertisement

Message
ttttt
mmm>>
A request for paper of size mmm.
PAPER>>
tttttt = TRAY1, FEEDER, TRAY2 (option).
REQUEST
Memory has overflowed for one of the following
reasons.
• Too much data on page.
MEMORY
• Too much macro data.
OVERFLOW
• Too much DLL data.
Press RECOVER to continue. Install extra memory or
reduce data on page.
The receive buffer memory has overflowed. Press
RECBUF
RECOVER to continue. The PC ignores printer busy
OVERFLOW
signal in the interface, check cable pin assignments.
Print processing speed could not follow the paper feed
PRINT
speed. Press RECOVER to continue. Simplify page
OVERRUN
formatting data .
Indicates an error in the network or RS232C interface.
HOST I/F
Check protocols of printer and host. Press RECOVER to
ERROR
continue.
TONER
Indicates that TONER LOW has been exceeded and the
EMP
cartridge should be replaced.
tttttt
Wrong paper size found. Open and close printer cover
SIZE ERR
to continue. Check paper size or paper double feed.
tttttt
Paper jam found, when fed from paper tray. Check paper
INPUT JAM
in the tray. Open and close printer cover to continue.
tttttt
Paper jam found, during paper feed. Remove misfed
FEED JAM
paper and close printer cover to continue.
tttttt
Paper jam found in paper exit area. Open printer cover,
EXIT JAM
remove paper, close printer cover to continue.
22
Description
Message
MENU
Settings Menu.
COVER
Cover is open. Press down firmly to close.
OPEN
EEPROM
EEPROM ID check error. Press RECOVER to reset
RESETTING
EEPROM to factory default.
Abnormality found in the printer. Switch printer off then
ERROR nn
on again to clear, if problem persists, contact service
representative.
Abnormality found in the controller. Switch printer off
ERROR On
then on again to clear, if problem persists, contact
aaaaaaaa
service representative.
aaaaaaaa = error address
SIMM-ROM
Flash SIMM sum check error.
ERROR
INITIAL-
Printer is in initialization mode after switching on, prior
IZING
to on- line mode.
Printer is requesting RESET button to be pressed for
RESET TO
more than 2 seconds, to write new menu data to
SAVE
EEPROM.
Description
OKIPAGE 14ex, 14i, 14i/n

Advertisement

Table of Contents
loading

This manual is also suitable for:

Page 14iPage 14i/nOkipage 14exOkipage 14iOkipage 14i/n

Table of Contents