Power System Checkout; Checking The Ac Power Adapter; Checking The Battery And Operational Charging - Lenovo thinkpad t440P Maintenance Manual

Hide thumbs Also See for thinkpad t440P:
Table of Contents

Advertisement

5. Use the arrow keys to select ATAPI CDx (x: 0, 1, ...) and then press Enter. The diagnostic program
will be launched automatically.
6. Follow the instructions on the screen to use the diagnostic program.

Power system checkout

To verify if a battery pack or an ac power adapter is functional, do the following:
1. Turn off the computer.
2. Connect the ac power adapter.
3. Turn on the computer. If the computer can be turned on, it means that either the battery pack or the ac
power adapter is functional.
4. Insert a straightened paper clip into the emergency reset hole to reset the computer. If the computer is
still powered on, it means that the ac power adapter is functional.
5. Turn off the computer.
6. Disconnect the ac power adapter and turn on the computer. If the computer can be turned on, it
means that the battery pack is functional.
If you suspect a power problem, see the appropriate one of the following power supply checkouts:
"Checking the ac power adapter" on page 27
"Checking the battery and operational charging" on page 27
"Checking the coin-cell battery" on page 28

Checking the ac power adapter

You are here because the computer fails only when the ac power adapter is used.
• If the power problem occurs only when the docking station or the port replicator is used, replace the
docking station or the port replicator.
• If the system status indicator does not blink three times when an ac power source is connected, check
the power cord of the ac power adapter for correct continuity and installation.
• If the computer does not charge during operation, go to "Checking the battery and operational charging"
on page 27.
To check the ac power adapter, do the following:
1. Unplug the ac power adapter cable from the computer.
2. Measure the output voltage at the plug of the ac power adapter cable. See the following illustration:
3
2
1
Note: Output voltage of pin 2 of the ac power adapter might differ from the one you are servicing.
3. If the voltage is not correct, replace the ac power adapter.
4. If the voltage is acceptable, replace the system board.
Note: Noise from the ac power adapter does not always indicate a defect.

Checking the battery and operational charging

This computer supports only batteries specially designed for this specific system and manufactured by
Lenovo or an authorized builder. The system does not support unauthorized batteries or batteries designed
(20V)
Pin
Voltage (V dc)
1
+20
2
0
3
Ground
.
Chapter 3
General checkout
27

Advertisement

Table of Contents
loading

Table of Contents