Advertisement
Quick Links
Hole Punch Kit
Technician's Installation Guide
1. Unpack the Hole Punch Kit and check the
contents:
[1] Hole Punch Unit
[2] Safety Labels
[3] Screw (for securing hole punch unit to finisher:
see step 14)
[4] Orange Cable (4 leads)
[5] Purple Cable (5 leads)
(P/N 42872902)
2. Remove the packing tape, blue spacers and
any other packing materials from the Hole
Punch Unit.
3. Turn off the printer.
4. On the back of the finisher/inverter unit,
unplug the inverter power cord (
connecting cord (
) and the
1
) to the finisher.
2
Advertisement
Related Manuals for Oki Hole Punch Kit 58372901
Summary of Contents for Oki Hole Punch Kit 58372901
- Page 1 (P/N 42872902) 2. Remove the packing tape, blue spacers and any other packing materials from the Hole Punch Unit. 3. Turn off the printer. 4. On the back of the finisher/inverter unit, unplug the inverter power cord ( connecting cord ( ) and the ) to the finisher.
- Page 2 5. Push in on the finisher release lever and slide the finisher away from the inverter. 6. Open the finisher front cover. 7. Squeeze the white locking tabs on the blue knob and pull it out of the finisher. 8. Remove the internal cover: a.
- Page 3 9. Remove the screws securing the rear cover (two on the left side [ ] and one on the right side [ ]), then remove the rear cover. 10. Remove the two screws at either end of the hole punch blank. 11.
- Page 4 12. Remove the top of the blank unit: you need this to install the hole punch unit. Store the bottom of the blank in case you ever remove the hole punch from the finisher. 13. Align the pins at either end of the hole punch unit with the holes in the finisher housing, then slide the hole punch unit into place.
- Page 5 17. Insert the orange cable (4 leads) into the connector on the hole punch unit board. 18. Insert the purple cable (5 leads) into the connector on the hole punch unit board. 19. Snap open the four cable harnesses, then thread the two cables through the harnesses and snap each one shut.
- Page 6 22. Reinstall the back cover and secure it in place: two screws on the left side one screw on the right side ( 23. Reinstall the internal front cover and secure ) and it with four screws.
- Page 7 26. Apply the appropriate language safety label: 27. Slide the finisher back into the inverter. Make sure it locks in place. 28. Reattach the cable between the finisher and inverter and the finisher power cable. 29. Turn on the printer.
- Page 8 30. Test the operation of the hole punch unit: a. With a suitable document open in a software application, select [File] → [Print]. b. Select the appropriate Oki printer, then click [Properties]. c. Click the [Job Options] tab. d. Under [Finisher], [Output Bin], select...